Red Dots, Optic Plates, Sights

Trijicon Bright & Tough™ Suppressor Night Sights are three-dot tritium iron sights that allow shooters the ability to line up their sights in both bright and low-light situations. While standard height sights do not provide an aiming solution when using a suppressed firearm, the additional height of suppressor night sights will clear the added height of a suppressor, allowing shooters the ability to line up their sights on target. Additionally, suppressor night sights can be used as back up iron sights with the Trijicon RMR®.

Trijicon Bright & Tough Suppressor Night Sights are three-dot tritium iron sights that allow shooters the ability to line up their sights in both bright and low-light situations. While standard height sights do not provide an aiming solution when using a suppressed firearm; the additional height of suppressor night sights will clear the added height of a suppressor, allowing shooters the ability to line up their sights on target. Additionally, suppressor night sights can be used as back up iron sights with the Trijicon RMR. Green lamps are warranted for 12 years from the date of manufacture.

Precision made optic plate for Aimpoint ACRO with rear sight insert

This plate is made specifically for the Viper optic footprint. It comes with the adapter plate, a set of screws to mount the plate to your AOS milled slide, and a pair of screws to mount the optic to the plate.

 

AOS Vortex Viper Plate sold as a single plate in either Rear Iron Forward of the Viper or Rear Iron Behind the Viper

This plate is made specifically for the Shield RMS optic footprint. It comes with the adapter plate, a set of screws to mount the plate to your AOS milled slide, and a pair of screws to mount the optic to the plate.

 

AOS Shield Optics RMS Plate sold as a single plate in either Rear Iron Forward of the RMS or Rear Iron Behind the RMS

 

Recommended Torque Specs for Plate Screws: 8-10 inch lbs with a tiny bit of blue loctite.

Recommended Torque Specs for Optic Screws: 10-12 inch lbs with a tiny bit of blue loctite.

This plate is made specifically for the 509T optic footprint. It comes with the adapter plate and a set of screws to mount the plate to your AOS milled slide (screws not needed to attach optic to plate, just picatinny clamp mount).

 

AOS Holosun 509T Plate sold as a single plate in either Rear Iron Forward of the RMR or Rear Iron Behind the RMR

  

Recommended Torque Specs for Plate Screws: 8-10 inch lbs with a tiny bit of blue loctite.

Recommended Torque Specs for Optic Screws: 10-12 inch lbs with a tiny bit of blue loctite.